For my figure I decided to refine the design to be more streamlined and more accessible while still having the same look and feel.
Initial design was too small as well as the tabs.
I printed the new and more accessible forms which came in 4 pages.
Some tabs had overlap on folds which I had to trim.
Base of the helmet done
Another tab overlap.
Some areas had too much tabs that I had to trim away.
Here I had to trim away a tab because it was in an awkward position. I should have attached it on the opposite side.
Visor/Middle part done
Glued together
here I had tabs missing that I took notes to add later on.
I had to cut a hole at the bottom to be able to glue the insides.
The example of tabs missing resulting in open folds in the inside of this top part.
Top of the helmet done.
3 part done
I added the smaller details on the front and sides and finished!
No comments:
Post a Comment